Filters

10

perfect, definitely recommended

  • Would you recommend us? Yes
8

4 Sterne: guter Service, gut behandelt

Positive

Schnelle Lieferung und Support reagiert schnell auf Anfragen

Verbesserungspunkte

Homepage nicht immer korrekt. Zum wiederholten mal habe ich Produkte über die Google Suche gefunden, aber auf der Hompage direkt selbst nicht.

  • Würden Sie uns weiterempfehlen? Ja
10

perfect, definitely recommended

  • Would you recommend us? Yes
10

perfect, definitely recommended

  • Would you recommend us? Yes
10

perfect, definitely recommended

  • Would you recommend us? Yes
10

perfect, definitely recommended

  • Would you recommend us? Yes
8

good service, well treated

  • Would you recommend us? Yes
8

good service, well treated

  • Would you recommend us? Yes
8

good service, well treated

  • Would you recommend us? Yes
10

perfect, definitely recommended

  • Would you recommend us? Yes
10

perfect, definitely recommended

  • Would you recommend us? Yes
9

good service, well treated

  • Would you recommend us? Yes
8

good service, well treated

  • Would you recommend us? Yes
10

perfect, definitely recommended

  • Would you recommend us? Yes
10

5 stars: perfect, definitely recommended

Positive

The communication is very fast, nice and always with a solution.

  • Would you recommend us? Yes
10

perfect, definitely recommended

  • Would you recommend us? Yes
7

3 stars: fine, a reasonable experience

Positive

Acceptable prices of printer kits Availability of materials is o.k.

Suggestions

Technical performance of printers could be more reliable (many printing failures even after careful calibration) Support through webpages could be more straightforward (empty categories in support section) Assembly instructions could be more clear, mistakes of references could be corrected.

  • Would you recommend us? Yes
7

3 stars: fine, a reasonable experience

Positive

High quality products. Fast delivery.

Suggestions

I have an Felix 3 3D printer. The printhead is often clocked. The reason why is that the filament melted in the head and if it gets back drawn, it sticks to the plasic part between heater and aluminium shaft. There is no improvement till now. A simple teflon ring can in the plastc part can solve the problem. This solution is available in the forum.

  • Would you recommend us? Yes
10

perfect, definitely recommended

  • Would you recommend us? Yes
10

5 stars: perfect, definitely recommended

Positive

Always ready for advise and help. Innovations keep going on for filament use on highly reliable printers.

Suggestions

Sharing of knowledge where possible and desired.

  • Would you recommend us? Yes
8

good service, well treated

  • Would you recommend us? Yes
9

good service, well treated

  • Would you recommend us? Yes
8

goede service, goed behandeld

  • Aanbevelen? Ja
5

2 stars: worse than expected

Positive

Seems to be okay printer

Suggestions

However its not easy to start.

  • Would you recommend us? Yes
5

worse than expected

  • Would you recommend us? No

Kiyoh Reviews

• Iedereen mag een review plaatsen zolang er wordt voldaan aan de gebruikersvoorwaarden en het privacybeleid
• We voeren geautomatiseerde en handmatige controles uit om valse reviews zoveel mogelijk tegen te gaan
• Reviews die op eigen initiatief zijn geschreven worden direct online getoond en binnen 72 uur geverifieerd
• Meer weten hoe deze reviewpagina tot stand komt? Lees dan hier.